3 Madhura Handling Systems

Capable of handling up to 100 gm/Nm3 dust loads with guaranteed emission level of even less than 10 mg/Nm3, this MS Bag Filter System is capable of handling very fine dust at low pressure. This bag filter is also capable of handling dusts with very low material density up to 100 kg/m3. These are flush mounted on top of silo/bin to vent pneumatic transport air or to keep the silo/bin under negative pressure to prevent dust escape while silo/bin is being mechanically filled.Features:Very compact, with filter length of 1000 mm & 2000 mm.Available in 2000 m3/h, 5000 m3/h, 10,000 m3/h, 15,000 m3/h & 20,000 m3/h with or without inbuilt fan.Filter life span of over 5 years even with abrasive dusts.Uses injector nozzle pulsing for most efficient online cleaning of filter, eliminates energy sapping conventional venturi and requires minimum pulsing at large intervals saving on compressed air energy.Laser cut bag holding plates and easy to install snap-fit filters ensure zero leakage, critical to emission control.Cage-less design. Fully moulded stiff single piece filter construction for easy handling & fitment.Available with filter media selection of spun-bond Polyester/Acrylic with surface treatments of oil/water repellant, anti-static, spark resistant, flame retardant, PTFE membranes etc to suit varied applications.As a stand-alone mechanical dust collector, cyclones are not capable of satisfying the current emission control regulations. However, it finds application in following industrial purposes:Classifiers to separate coarse and fine particulates.As pre-filter to reduce the dust load to main dust collector.Collection of grainy and lumpy materials in a lean phase pneumatic transport.As a spark arrestor before a main dust collector.